Falcon 900: Landing Gear Door Bracket Cracks
These standoff brackets have a tendency to crack if the aft door rubber bumper stop is out of adjustment.
Read More...
These standoff brackets have a tendency to crack if the aft door rubber bumper stop is out of adjustment.
Read More...
In addition to Dassault Falcon Jet’s latest cold weather Service Advisory, care is needed when parking your F50 outside to make sure that snow or ice does not accumulate under the airbrakes.
Read More...
Dassault has just issued a new Service Advisory explaining a new “CPCP path of compliance” for the Falcon 50s.
Read More...
Duncan Aviation technicians have found the V-Band Clamp installed incorrectly on a Falcon 50B and 50EX.
Read More...
Falcon jack pads fit very tight and don't easily seat down properly when installed. The threads on the pad can be chased to ease the turning torque required to install the pad.
Read More...
During the removal and replacement of the flap drive 90° gear boxes, pay particular attention to the orientation of the mounts attaching the gearboxes to the aft spar.
Read More...
After removal and reinstallation of the after-bodies for maintenance or engine change, take an extra step to avoid damage during deployment.
Read More...
Recently, Dassault Aviation released several service bulletins and Falcon Service Advisories announcing the installation of ‘wing tank modifications’ for all of the Falcon 50/900/2000 series aircraft.
Read More...
The wing leading edge upper removable panels on Falcon 50, 900 and 2000s are installed with differing length screws depending on location.
Read More...
Duncan Aviation technicians have found a bell-crank in the aft baggage door on a Falcon 2000 has been striking a torque tube bolt during the closing operation of the door.
Read More...
During inspections of the Falcon 50 baggage door, Duncan Aviation technicians have found a formed rib to be cracked in the radius. During the next 2A+, make sure to conduct a thorough visual inspection of this area. Because the baggage door is part of the pressure vessel, it requires the manufacture to be notified...
Read More...
This information is meant to help Falcon operators who are new to the EASy cockpit or for those who may have forgotten how the APU Oil Level Test sequence operates.
Read More...
Pratt & Whitney has recently notified Falcon 2000EX operators of ESP of a new service enhancement for their engines. This upgrade will allow operators who currently or wish to fly “on condition”...
Read More...
When removing the over-the-wing anti-ice lines during the Falcon C inspection, watch for corrosion on the clamps and tubing holding the left-hand and right-hand peri-seal heat shields in place
Read More...